Sidebar
tem:procedures
This is an old revision of the document!
Table of Contents
Procedures
Start work
- HT→FEG Standby Mode→Normal (it takes ~13min)
- Mount sample
- Check nitrogen pressure!
- Insert holder till the first notch Air→Pump (wait for green light)
- Fill ACD with liquid nitrogen (in two steps)
- Fully insert holder
- Select holder type!
End work
- Stage Neutral
- Check nitrogen pressure!
- Pull holder till last notch
- Pump→Air, wait for nitrogen and remove the holder
- Mount ACD heater, Maintenance→ACD & Bake→ACD Heat→ON (turns off automatically)
- HT→FEG Standby Mode→Standby
Alignment
- GUNA(F3): center with DEF @ Spot1 and SHIFT @ Spot5, or Anode wobler(F5)
- COND STIG: make round with DEF
- Tilt and shift purity
- STD FOCUS adjust Z (minimal contrast, no hallo, or no motion with IMAGE WOBB)
- OBJ wobler (F4) make feature stationary with DEF(BRIGHT TILT)
- make fft round with DEF(OBJ STIG)
- SPECTRUM→move ZLP to center using FL lens
- Filter→Slit→IN move slit to center using position
- back to IMAGE, center circle with Isochromacity
- center diffraction win DEF(PLA)
After bakeout
- Cycle BEAM VALVE with HT OFF
- Open EDX detector valve with BEAM VALVE closed
- HT→HT Conditioning→Auto Procedure→Start (it takes ~60 min)
Beam shower
- ?
tem/procedures.1448401200.txt.gz · Last modified: 2021/10/25 08:53 (external edit)
